CompuLab SBC-X270 Bedienungsanleitung PDF herunterladen (Seite 12)

SB-X270 PC/104+ Single Board Computer

CompuLab LTD.

3.3. USB header & LCD voltage control (P15)

1x26, 100 mil header. USB pin assignment is directly compatible with standard

cables/connectors.

Pin Name

Wire

Color

Pin Name Wire

Color

01 VCC3.3 14 USB3-P Green

02 VSRC-LCD 15 GND Black

03 VCC5 16 SHIELD

04 GND 17 VCC-USB2 Red

05 VCC-USB1 Red 18 USB2-N White

06 USB1-N White 19 USB2-P Green

07 USB1-P Green 20 GND Black

08 GND Black 21 SHIELD

09 SHIELD 22 VCC-USB4 Red

10 VCC-USB3 23 USB4-N White

11 VCC-USB3-BUS 24 USB4-P Green

12 VCC-USB3-BUS Red 25 GND Black

13 USB3-N White 26 SHIELD

Notes

• An LCD power supply voltage selection jumper must be assembled in either 1-2 or 2-3

position for normal LCD functionality.

• A jumper must be assembled on pins 10-11 to provide power, if USB3 is used in host

mode. A jumper must be removed when USB3 is used in slave mode. Jumper only

selects power; the switching between host and slave modes is controlled by ARMmon

command.

• If card includes “F” (front panel) option, then USB1 is routed to the front panel rather

than to P15 header. To change this assignment, user must remove RN40 bypass and

solder it in RN38 location. In cards without “F” option, this is a default assignment.

• USB4 port is available only with CM-X270W module.

3.4. Audio, Touchscreen, Write-protect (P14)

P14 - 1x18 100 mil header

Pin Name Pin Name

1 TSMX 10 GND

2 TSMY 11 GND

3 TSPY 12 LOUT-L

4 TSPX 13 LIN-R

5 NAND-WP#* 14 GND

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 40 41

Keine Kommentare

CompuLab SBC-X270 Bedienungsanleitung Seite 12